Table of Contents
Advertisement
Page 188 of 436
NN43021-310
Standard 06.01
Connecting a system terminal or modem
3
At the local end, configure the modem.
Follow the manufacturer's instructions to set the modem for 9600 baud,
autoanswer, dumb mode, command recognition OFF, and command
echo OFF.
4
At the local end, connect NT8D95 cables to:
•
J21 on the I/O panel in the rear of the Core or Core/Network Modules
•
the SDI port on the I/O panel in the rear of the Network module
5
At the local end, connect NT8D84 cables to the SDI Paddle Board at the
Core/Network backplane to the I/O panel in the rear of the cPCI Core/
Network Module.
6
At the local end, connect NT8D95 cables from the I/O panels to a
matching connector on the switch box.
a.
If you are using an A0377992 ABCDE box, connect cables as
follows.
— Connect CPU 0 to connector A.
— Connect CPU 1 to connector B.
— Connect the SDI port to connector D (connector C is common).
7
At the local end, connect an NT8D95 cable from the switch box to the
modem.
8
At the local end, connect the cable from the modem to an RJ11 telephone
jack. If a cable is required, connect an NT8D46 cable to the modem and
to the RJ11 jack.
9
At the local end, configure the switch box as needed to communicate with
the COM2 ports.
•
During normal operation, set the switch to the SDI port.
•
For debugging, set the switch to the active CPU.
•
For patch downloading, set the switch to the inactive CPU.
March 2013
End of Procedure
Advertisement
Table of Contents
