Table of Contents
Advertisement
Page 412 of 436
NN43021-310
Standard 06.01
lnstalling a Signaling Server
Note: When you perform Procedure 75, "Connecting an IBM COTS
server," on
page
Procedure 75
Connecting an IBM COTS server
1
Connect the IBM server to the TLAN subnet. Insert the RJ-45 CAT5 (or
better) cable into the TLAN Ethernet port on the back of the server. Insert
the other end of the cable into the TLAN subnet of the Layer 2 switch.
2
Connect the IBM server to the ELAN subnet. Insert the RJ-45 CAT5 (or
better) cable into the ELAN Ethernet port on the back of the server. Insert
the other end of the cable into the ELAN subnet of the Layer 2 switch.
3
Connect a DTE–DTE null modem serial cable from the serial port on the
back of the server to the serial port on a maintenance terminal. The IBM
x3350 requires a NTRX26NPE6 9 pin female to 9 pin female null modem
cable.
4
Connect the IBM server power cord.
a.
Check that the power cord is the type required in the region where
you use the server. Do not modify or use the supplied AC power cord
if it is not the correct type.
b.
Attach the female end of the power cord to the mating AC power
receptacle on the server back panel. Plug the male end of the AC
power cord into the AC power source (wall outlet).
5
Set the baud rate for the serial port on the server to 9600 b/ps. See Avaya
Linux Platform Base and Applications Installation and Commissioning
(NN43001-315).
Note: The IBM X306m Signaling Server ships with the serial port
configured to 9600 b/ps.
6
Configure the connected maintenance terminal. See Avaya Linux
Platform Base and Applications Installation and Commissioning
(NN43001-315).
7
Press the Power switch.
Note: For more information about operating information, see the IBM
User Guide for your IBM server.
March 2013
412, see Figure 155 or Figure 156.
End of Procedure
Advertisement
Table of Contents
