PTX1000 Packet Transport Router Hardware Guide
70
Figure 26: Removing the Screws Holding the Cover on the PTX1000
Align one of the front-mounting rails with the screw holes on the side of the chassis
4.
(see
Figure 27 on page
Figure 27: Attaching Front-Mounting Rails to the PTX1000
31
Attach the mounting rail to the PTX1000 by using 11 flat-head M4x6-mm Phillips
5.
mounting screws. Tighten the screws.
Repeat Step
4
and Step
6.
Perform one of the following steps:
7.
Use a mechanical lift to position the PTX1000 in the rack so that the ears on the
front-mounting rails are aligned with the rack holes.
Have two persons grasp both sides of the PTX1000, lift it, and position it in the rack
so that the ears on the front-mounting rails are aligned with the rack holes.
Have another person secure the front of the PTX1000 to the rack by using eight
8.
mounting screws (and cage nuts and washers if your rack requires them). Tighten the
screws.
Continue to support the PTX1000 while sliding the rear-mounting blades into the
9.
channel of the side-mounting rails and securing the blades to the rack (see
Figure 28 on page
71). Use eight mounting screws (and cage nuts and washers if your
rack requires them) to attach the blade to the rack. Tighten the screws.
70).
5
on the opposite side of the PTX1000.
Copyright © 2018, Juniper Networks, Inc.