Replacing An Mx104 Dc Power Supply; Removing An Mx104 Dc Power Supply; Figure 35: Installing An Ac Power Supply - Juniper MX104 Hardware Manual

MX104 3D Universal Edge Router Hardware Guide
Related
Documentation

Replacing an MX104 DC Power Supply

Removing an MX104 DC Power Supply

98

Figure 35: Installing an AC Power Supply

Connecting AC Power Cords to the MX104 Router on page 53
MX104 AC Power Specifications on page 159
MX104 AC Power Cord Specifications on page 160
Removing an MX104 DC Power Supply on page 98
1.
Installing an MX104 DC Power Supply on page 101
2.
To remove a DC power supply from the router, you need the following tools:
Phillips (+) screwdriver, number 2
ESD grounding wrist strap
Before you remove a power supply, be aware of the following:
NOTE: The minimum number of power supplies must be present in the router
at all times.
WARNING: Before performing DC power procedures, ensure that power is
removed from the DC circuit. To ensure that all power is off, locate the circuit
breaker on the panel board that services the DC circuit, switch the circuit
breaker to the off position, and tape the switch handle of the circuit breaker
in the off position.
Copyright © 2014, Juniper Networks, Inc.