Installing A Mx960 Ac Power Supply - Juniper MX960 Hardware Manual

user@host>request chassis fpc slot slot-number online
For more information about the command, see the
To bring a PIC online:
Press the PIC offline/online button until the PIC LED lights green. For a PIC installed in FPC3, use
a narrow-ended tool that fits inside the opening that leads to the button.
Issue the following CLI command:
user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online
For more information about the command, see the
To bring a MIC online:
Press the MIC offline/online button until the MIC LED lights green.
Issue the following CLI command:
user@host>request chassis mic fpc-slot mpc-slot pic-slot mic-slot online
For more information about the command, see the
The normal functioning indicator LED confirms that the component is online. You can also verify correct
DPC or MPC functioning by issuing the show chassis fpc command or the correct PIC or MIC functioning
by issuing the show chassis fpc pic-status command.
RELATED DOCUMENTATION
Preventing Electrostatic Discharge Damage to an MX960 Router
Removing a Cable on an MX960 DPC, MPC, MIC, or PIC | 523
Maintaining Cables That Connect to MX960 DPCs, MPCs, MICs, or PICs | 617

Installing a MX960 AC Power Supply

To install an AC power supply (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Move the AC input switch in the chassis above the empty power supply slot to the off (O) position.
CLI
CLI
CLI
Figure 148 on page 412):
Explorer.
Explorer.
Explorer.
410