Sp Mode Tables-Basic Model; Sp1-Xxx (Feed) - Ricoh Aficio 1515 Service Manual

9 March 2004
5.1.2 SP MODE TABLES–BASIC MODEL
The tables in this section (5.1.2) list the service programs (SPs) that are available
when the controller box is NOT installed. For the SPs that are available with the
controller box, see the next section (5.1.3).
Keys in the tables:
• Asterisk (*): The settings are saved in the NVRAM. Most of them return to the
default values when you execute SP5-801-002 (☛5.1.5).
• DFU: The program is for the design/factory use only. Do not change the settings.
• Brackets ([ ]): The brackets enclose the setting rage, default value, and minimum
step with unit ([Minimum ∼ Maximum / Default / Step]).

SP1-XXX (Feed)

1001* Leading Edge Registration
1001 1 All Trays
1001 2 By-pass
1001 3 Duplex
1002* Side-to-Side Registration
1002 1 1st Tray
1002 2 Optional Tray
1002 5 By-pass
1002 6 Duplex
1003* Paper Feed Timing
1003 1 1st tray
1003 3 Optional tray
1003 4 By-pass feed
1003 5 Duplex
1103*
Fusing Idling
1103 1 Enables or disables the contact-release control. The table below lists the results.
Setting
C-R control
Idling time
Fusing quality Lower
[–9.0 ~ 9.0 / 0.0 / 0.1 mm/step]
Adjusts the leading-edge registration (☛ 3.14).
[–9.0 ~ 9.0 / 0.0 / 0.1 mm/step]
Adjusts the side-to-side registration (☛ 3.14). SP1-
002-001 is applied to all trays. SP1-002-002 and
005 adjusts the difference from SP1-002-001.
Adjusts the side-to-side registration of the 2nd side
in duplex copying. The 1st side is adjusted by SP1-
002-001 through 005.
Adjusts the amount of paper buckle on the
registration roller.
[0 ~ 10 / 5 / 1 mm/step]
[0 ~ 10 / 5 / 1 mm/step]
[0 ~ 10 / 5 / 1 mm/step]
[0 ~ 20 / 5 / 1 mm/step]
[0 = No / 1 = Yes]
0 = No 1 = Yes
Works Does not work
Shorter Longer
Higher
5-3
SERVICE PROGRAM