15-32
1968 P O N T I A C SERVICE MANUAL
©
OUTER
©
QUARTER
O
PANEL
Fig. 15-44
Electric Antenna—Pontiac Wagon
10. Remove
bottom
insulator
and
water seal
washer from tubular fitting, using wire hook or long-
nose pliers.
11. Thread nylon cord through bottom insulator
with small diameter end down. Then thread nylon
cord through water seal washer.
12. Apply 12 volts D . C . (down direction of mast)
to power leads and feed nylon cord into drive assem
bly. Do not allow bend or kink to occur in nylon cord.
NOTE:
Push water seal washer and bottom in
sulator all the way down into tubular fitting before
nylon cord completely disappears into drive
as
sembly. Remove power, if necessary,
to seat these
parts.
E X I S T I N G W I R E
A S S Y
Fig. 15-45
Electric Antenna —Ternpest
13. Push .400 tube section down into tubular fitting
on drive. Make sure that upper edge of flange on
insulator bushing is below center of 3 holes in tubu
lar fitting.
14. Install support tube (minus lead-in flange, pin
and insulator assembly) in proper position, making
sure hook-up wire is extended through proper hole
in support tube.
15. Install three screws to hold support tube to
drive assembly.
16. Solder
hook-up
wire
to pin and insulator
assembly.
CA UTION:
Do not overheat by slow
soldering.
17. Assemble flange over pin and insulator assem
bly and install two screws.