12-36
1968 P O N T I A C SERVICE MANUAL
M B
F i g . 12-39
Installing Lock P a w l - P o n t i a c
NOTE:
Screws,
nuts and lockwashers for
reas
sembling
cover to wiper are contained in a
service
repair
package.
3. Remove output gear and shaft assembly, then
slide intermediate gear and pinion and pinion spring
washer off shaft.
4. Remove terminal board and park switch assem
bly as follows:
a. Unsolder motor leads from terminals.
b. Drill out rivets that secure terminal board
and park switch ground strap to cover.
NOTE:
Screws
and nuts for attaching a
replace
ment terminal board-park switch are included with
replacement
assembly.
ASSEMBLY
Reverse steps 1 through 4 above except as noted:
1. Reassembly of gear cover - be sure cover is
located properly over locating dowel pins and be sure
to reinstall ground strap and gasket.
2. Reassembly of crank arm - operate wiper to
park position and install crank arm on output shaft so
that identification marks line up with those in cover
(Fig. 12-43). Clamp crank in vise before securing
retaining nut.
. 4 .
INNER
SPACER
WASHER
/
t
DRIVE PAWL
LOCK PAWL
GUIDE PIN
GUIDE PIN
I
I
F i g . 12-40
Installing G e a r and Drive Shaft—Pontiac
TEMPEST
MOTOR
SECTION
DISASSEMBLE AND ASSEMBLE
Refer to Fig. 12-42.
v
%
/ • •
X
/
N O T E
A L I G N I N G
P I N E X T E N D I N G
T H R O U G H C A M
F i g . 12-41
Assembling Washer Pump to Wiper—Pontiac