Pontiac tempest 1968 Service Manual page 452

T U R B O HYDRA-MA T I C TRANSMISSION
7E-17
Fig. 7 E - 2 8 Location of Case Extension Gasket
h. Read resulting travel or end play. Should be
.003 M -.024 n .
Selective washer controlling this end play is the
phenolic resin washer located between pump cover
and forward clutch housing. If more or less washer
thickness is required to bring end play within speci­
fications, select proper washer from the following
chart:
Thickness Color
.060 - .064 Yellow
.071 - .075 Blue
.082 - .086 Red
.093 - .097 Brown
.104 - .108 Green
.115 - .119 Black
.126 - .130 Purple
DIAL
INDICATOR '
J 8 0 0 1
Fig. 7 E - 3 0 Removing Front Seal
NOTE: An oil soaked washer may tend to dis­
color, so it will be necessary to measure washer
for its actual thickness.
REMOVAL OF OIL PUMP
1. If necessary to replace, pry front seal from
pump (Fig. 7E-30).
2. Remove pump attaching bolts.
3. Install 3/8-16 threaded slide hammer adapters
J 6125-2 into bolt holes in pump body, attach slide
hammers J 6125-1 and remove pump assembly from
case (See Fig. 7E-31 for location of threaded holes).
4. Remove and discard pump to case seal ring
and gasket.
Fig. 7E-29 Checking Front Unit End Play
Fig. 7E-31 Removing Pump Assembly