Pontiac tempest 1968 Service Manual page 527

7F-26
1968 P O N T I A C SERVICE MANUAL
O I L P U M P
O I L S E A L
F i g . 7 F - 7 6 Removing O i l Pump Seal
STAT OR SHAFT BUSHING R E P L A C E M E N T
1. While holding front end of stator shaft in one
hand, use tool J 21424-7, a suitable brass drift and
a hammer to drive bushing out of front end of stator
shaft (Fig. 7F-78).
2. Install stator shaft bushing as follows: Support
pump assembly on J 21424-3 before installing bush­
ing. Install bushing into the front end of stator
shaft. Using installer J 21424-7 and drive handle
J 8092, tap bushing into shaft until it bottoms on
shoulder (Fig. 7F-79).
CA UTION: Extreme care must be taken so bush­
ing is not driven past shoulder.
ASSEMBLY
1. Using tool J 21359, install new oil seal (Fig.
7F-80).
i iffffr"
•J 21424-7
BRASS DRIFT
F i g . 7 F - 7 8 Removing Stator Shaft Bushing
2. Install new oil pump to case seal.
3. Assemble pressure regulator valve, washer,
spring boost valve and sleeve (Fig. 7F-75).
NOTE: Some transmissions incorporate a C type
spring washer and may have one or two C type
spacers behind the washer. Install the same num­
ber of spacers originally removed.
4„ Compress pressure regulator valve spring by
pressing on boost valve sleeve. Install snap ring.
5. If previously removed, install converter blow
off valve and spring in the pump cover. Depress
spring and install retaining pin (Fig. 7F-73).
J 8092
J 21424-7
F i g . 7 F - 7 7 Checking G e a r End Clearance
F i g . 7 F - 7 9 Installing Stator Shaft Bushing