Pontiac tempest 1968 Service Manual page 457

7E-22 1968 P O N T I A C SERVICE M A N U A L
S E L E C T I V E W A S H E R
A
• 9
Fig. 7E-48 Removing Selective Washer
NOTE: One race may have been removed with
center support.
4
9
Remove reaction carrier and roller clutch as­
sembly (Fig. 7E-52).
5. Remove front internal gear ring from output
carrier assembly.
6. Remove sun gear (Fig. 7E-53).
7. Remove reaction carrier to output carrier
thrust washer.
8. Turn carrier assembly over.
9. Remove output shaft to output carrier snap ring
(Fig. 7E-54).
10. Remove output shaft.
^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ •
H 5 H H
ROLLER
C L U T C H
• 4
Fig. 7 E - 5 0 Removing Case Center Support Assembly
NOTE: If replacement of drive speedo gear is
necessary, remove in following manner:
a. Install speedo gear removing tool J 21427
and J 8433 and bolts J 21985 on output shaft and
remove drive speedo gear (Fig. 7E-55).
b. Install new drive speedo gear and drive to
location 11 29/64" below end of output shaft for
models PA, P B , P C , PG and PH and 5 21/32"
below end of output shaft for models PQ, P T , PX
and P Y , using J 21028 (cup side up) and J 6133
(Fig. 7E-56).
THRUST W A S H E R
C O N S T A N T BLEED
O R I F I C E P L U G
Fig. 7E-49 Removing Rear Band
Fig. 7E-51 Removing Center Suppo; : • Thrus: Wcslv^v