Pontiac tempest 1968 Service Manual page 383

7A-2
1968 P O N T I A C SERVICE M A N U A L
2. Insert tool J 4830-02 over output shaft and
tighten set screw.
3. Attach slide hammer J 2619. Using hammer,
pull bushing and seal from extension housing.
4. Start new bushing Into extension housing.
5. Using tool J 6403-1 and soft hammer, tap bush­
ing into place.
6. Install new seal, using tool J 6403-1 and collar
J 6403-2.
7. Reinstall drive shaft.
MAJOR REPAIRS
TRANSMISSION-REMOVE
1. Disconnect speedometer cable.
2. Disconnect shift control rods from transmission.
3. Remove propeller shaft.
4. Support rear of engine and remove transmission
mount.
5. Remove four (4) crossmember bolts and slide
member rearward.
6. Remove two (2) upper transmission to flywheel
housing bolts and insert guide pins.
7. Remove two (2) lower transmission to flywheel
housing attaching bolts.
8. Slide transmission straight back on guide pins
until the main drive gear splines are free of splines
in clutch friction plate.
9. Remove transmission.
INPUT SHAFT SEAL REPLACEMENT
1. Remove transmission from car.
2. Remove input shaft bearing retainer.
3. Remove seal from retainer by prying out with
screwdriver.
A L I G N S H I F T L E V E R S IN N E U T R A L
P O S I T I O N B Y I N S E R T I N G A
. 1 8 6 / . 185 D I A . G A G E P I N T H R O U G H
( R E V . & 1st.) H O L E S IN L E V E R S A S SHOWN
A
V E R T I C A L <£ O F C O L U M N
F R A M E
T R A N S M I S S I O N A S S Y .
k -
i i i
\ y \
L E V E R ( 1 s t . & R E V . )
<$>
B R A C K E T A S S Y .
L E V E R (2nd. & 3rd.)
L U B R I C A N T A S I N D I C A T E D
WITH C H A S S I S L U B R I C A N T
F i g . 7 A - 1 Pontiac Column Shift Controls