9-12
1968 P O N T I A C SERVICE MANUAL
Fig. 9 - 1 6
Mounting Column in Vise by Tapping Plate
6. Remove the three bolts and the alignment plate
just above the lower gearshift levers (see Figure
9-18).
2nd & 3rd LEVERS
FIRST & REVERSE LEVER
ASSEMBLY
"A
Y
\ADAPTER ,
\
/
A T T A C H I N G (2) NUTS
LEVERWCER
REINFORCEMENT R I N G
ADAPTER BOLTS
LOWER B E A R I N G ASSEMBLY
7. The adapter and bearing, first and reverse lever
and lever spacer may be withdrawn from the lower
end.
8
0
The shift tube may now be withdrawn from the
lower end.
9. Remove the lower bowl bearing with a long
wooden handle such as a broomstick, push out from
the bottom.
NOTE:
The lower bowl bearing may be
reused only with this jacket.
10. Press the lower bearing out of the adapter, if
necessary.
11. Cut and unwrap mesh cover,
if required.
C . Assemble Lower End
Apply a thin coating of lithium soap grease to a l l
friction surfaces.
1. Rewrap mesh cover.
Use friction tape to hold
in place.
2. P r e s s the lower bearing into the adpater.
L O W E R B E A R I N G
P R E - L O A D S P R I N G
C L A M P
\
X
L O W E R
S T E E R I N G
S H A F T
U P P E R
S T E E R I N G
S H A F T
\
P O T JOI N T ASS' Y
F i g . 9 - 1 7
Removing Pot Joint and Lower Shaft from
Upper Steering Shaft (Tempest Only)
F i g . 9 - 1 8
Lower Shift Levers and Adapter (Pontiac Shown)
3. Install lower shift bowl bearing by pressing into
jacket with tool J 22572 (Fig. 9-19).
Perform steps 4 through 8 on all cars equipped
with column shift manual transmission.
4. Install shift tube and assemble the lever spacer,
first and reverse lever, adapter assembly and align
ment plate to the lower end of the jacket and loosely
assemble the three bolts.
CA UTION:
Friction surfaces of lower levers and
mating bearing surfaces must be greased.
5. Place a .005" maximum shim on each side of
steering shaft between either lever and the spacer
(Fig.
9-20).
By using two shims the possibility of
cocking the lever is eliminated.
6. Rotate the lower bearing adapter
assembly
clockwise viewed from the bottom with tool J 22568
until levers are bottomed out.
NOTE:
Standard spanner wrench holes are
lo
cated at the bottom end of the adpater assembly.
B O W L L O W E R B E A R I N G
. . . U i ^ - M M, r,
y
„ ••..,vr»q 4
J 2 2 5 7 2
F i g . 9 - 1 9
Installing Lower Bowl Bearing