Pontiac tempest 1968 Service Manual page 398

T H R E E SPEED S A G I N A W MANUAL TRANSMISSION 7B-3
5. Using tool J 6403-01 and soft hammer, tap
bushing into place (Fig. 7B-7).
6. Install new seal, using tool J 6403-01 and collar
J 6403-02 (Fig. 7B-5).
TRANSMISSION SIDE COVER-
REMOVE AND DISASSEMBLE
It is not necessary to remove transmission from
vehicle for inspection or replacement of parts in
transmission side cover assembly, but cover itself
must be removed from transmission case (Fig.
7B-8).
1. Loosen side cover bolts to allow transmission
fluid to drain.
2. Disconnect control rods from levers.
3. Remove side cover from transmission case.
4. Disassemble side cover by removing detent cam
spring, shifter forks and shafts, detent cam retainer
and detent cams.
5. Inspect and replace necessary parts.
6. Inspect shifter shaft O-rings and replace if
necessary.