Pontiac tempest 1968 Service Manual page 474

TURBO H Y D R A - M A T I C TRANSMISSION 7E-39
J 2 1 3 6 2
J 2 1 4 0 9
Fig. 7 E - 9 8 Installing Direct Clutch Piston
C H E C K BALL
/
BLIND HOLES
• t
\
/
DIRECT CLUTCH
F O R W A R D CLUTCH
^ DIRECT CLUTCH
BACKING PLATE
. FLAT STEEL PLATES (4)
^ COMPOSITION PLATES (5)
- WAVED STEEL PLATE (1)
4 ^
, 1
NOTE: 5 FLAT
STEEL P L A T E S -
N O WAVED STEEL
PLATE IN PQ
MODEL
Fig. 7E-101 Installing Direct Clutch Backing Plate,
Composition Plates and Steel Plates
10. Install backing plate retaining snap ring (Fig.
7E-102).
11. Turn unit over and install one spring bushing,
cup side up, over inner race.
12. Install sprag assembly into outer race.
13. With ridge or shoulder on inner cage down,
start sprag and outer race over inner race with
clockwise turning motion (Fig. 7E-103).
NOTE: Outer race should not turn counterclock­
wise after installation.
F i g . 7 E - 9 9 Identification of Direct Clutch Piston
^ . J 6 1 2 9
1 J 4 6 7 0
• B f l B H L ^
- A J 8 7 6 5
flSBSHB
. S N A P R I N G
F i g . 7 E - 1 0 0 Installing Direct Clutch Spring Retainer
and Snap Ring
F i g . 7 E - 1 0 2 Installing Direct Clutch Housing
to Backing Plate Snap Ring