9 - 1 6
1968 P O N T I A C SERVICE M A N U A L
SIGNAL SWITCH
SCREWS
HBfp
• B P
/
STEERING
SHAFT
Fig. 9-22 Signal Switch Removal
bezel by removing two attaching screws on each side
of bezel.
7
0
Push in hazard warning knob, remove knob and
remove turn signal cover using special tool No.
J 22598 (Fig. 9-9).
8. Remove the three signal switch screws with a
Phillips screwdriver and let the signal switch as
sembly hang by its wires (Fig. 9-22)
0
NOTE:
On some columns, the clearance between
the bowl and mast jacket is sufficient to allow re
moval of the signal switch at this time.
> 9„ Install tilt release lever and place column in
full up position.
Remove tilt spring retainer using
screwdriver blade that just fits into slot opening.
Insert screwdriver and press in approximately 3/16".
Rotate retainer 1/8 turn clockwise until ears align
12 S I D E D N U T
J22599
s
\
I N N E R R A C E S E A T
I N N E R R A C E
Fig. 9-24
Removing Pivot Pin
with grooves in housing and remove retainer and
spring.
WARNING:
Care should be taken when releasing
tilt spring due to high compression rate of spring.
10. While holding end of steering shaft remove the
12-sided bearing locknut, inner race seat and inner
race with tool J 22599 (Fig. 9-23).
11. Remove two pivot pins using tool J 21854-01
(Fig. 9-24).
12. Pull up on tilt release lever to disengage lock
shoes and lift off bearing housing. Remove tilt re
lease lever and remove bearing from housing as
sembly.
13. To service lock shoes, release springs or shoe
release, drive lock shoe pin flush with housing face
if there is not enough clearance for driving the r e
lease pin out of the housing. Hold the shoe springs
in compression by rocking lock shoes in to relieve
the load on the shoe release lever, as the release
J 22635
S
•
F i g . 9-23 Removal of 12-Sided N u t
F i g . 9 - 2 5 Removing Tilt Release Lever Pin