T U R B O H Y D R A - M A T I C
TRANSMISSION
7E-15
SEP.VO COVER
ATTACHING SCREWS
Fig. 7 E - 2 0
Removing Rear Servo Cover Attaching Screws
BAND A P P L Y PIN S E L E C T I O N
a. Attach band apply pin and fixture J 21370-5
and J 21370-6 to transmission case with attaching
screws.
b. Apply 25 ft. lb. torque and select proper pin
to be used during assembly of transmission.
There
are
three
selective
pins identified
as
follows:
a. If both steps of J 21370-5 are below the
gauge surface, the long pin, identified by 3 rings,
should be used.
b. If the gauge surface is between the steps,
the medium pin, identified by 2 rings, should be
used.
TORQUE
WRENCH-
J 21370-6
( P H I
J 21370-5
illijF
Fig. 7E-22
Checking Rear Band Pin
c. If both steps are above the gauge surface,
the short pin, identified by 1 ring, should be used.
Identification rings are located on band lug end of
the pin. Selecting the proper pin is equivalent of ad
justing the band.
5. Remove
solenoid
attaching screws,
solenoid
assembly and.gasket (Fig. 7E-23).
6. Withdraw detent solenoid case connector sleeve
and O-ring seal (Fig. 7E-24).
7. Remove control valve assembly spacer plate
and gasket.
8. Remove six (6) check balls from cored pas
sages in transmission case (Fig. 7E-25).
Fig. 7E-21
Removing Rear Servo
Fig. 7E-23
Removing Detent Solenoid and Gasket