Pontiac tempest 1968 Service Manual page 396

7B-1
T H R E E
SPEED SAGINAW MANUAL
TRANSMISSION
CONTENTS OF THIS SECTION
SUBJECT PAGE
Description 7B-1
Periodic Service
Transmission . 7B-1
Shift Control 7B-1
On Car Adjustments
Linkage Adjustment - Column Shift . . . 7B-1
Linkage Adjustment - Floor Shift . . . . 7B-1
Minor Repairs
Extension Housing S e a l -
Remove and Replace . . . . . 7B-2
Extension Housing Seal and Bushing-
Remove and Replace 7B-2
Transmission Side C o v e r -
Remove and Disassemble 7B-3
Assemble and Install 7B-4
Major Repairs
Transmission—Remove . . . . . . . . . . . 7B-4
SUBJECT PAGE
Transmission— Disassemble 7B-6
Cleaning and Inspection 7B-7
Transmission Case 7B-8
Bearing Rollers 7B-8
Gears . 7B-8
Countergear Assembly 7B-8
Front Bearing Retainer Oil Seal . . . . 7B-8
Transmission—Assemble
Mainshaft—Assemble 7B-8
Countergear—Assemble 7B-10
Transmission-Assemble 7B-10
Transmission- Install in Vehicle . . . . . . 7B-12
Firebird Driveline Damper 7B-13
Specifications 7B-13
Special Tools 7B-14
DESCRIPTION
The Saginaw three speed manual transmission is
used as the standard equipment transmission on all
Tempest and Firebird models except those equipped
with the 400 cu. in. V-8 engine.
Gear ratios for the 6-cylinder engines are 2.85:1
in first, 1.68:1 in second, 1:00:1 in high and 2.95:1
in reverse. The 8-cylinder engine gear ratios are
2.54:1 in first, 1.50:1 in second, 1.00:1 in high and
2.63:1in reverse.
PERIODIC SERVICE
TRANSMISSION
No periodic service of the transmission is r e ­
quired except checking for leaks and proper lubri­
cation level every 6000 miles.
If there is evidence of leakage, leak should be
corrected and lubrication added as needed. Refill
capacity is 3-1/2 pints.
Use SAE 90 multi-purpose Gear Lubricant. No
special additive to this lubrication is required or
recommended.
SHIFT CONTROL
No periodic service of the shift control is r e ­
quired. Certain parts are lubricated on assembly
and require further lubrication only when parts be­
come dry and sticky.
ON CAR ADJUSTMENTS
LINKAGE ADJUSTMENT-COLUMN SHIFT
(Fig. 7B-1 and Fig. 7B-2)
1. Set transmission control levers in neutral po­
sition (see view A).
NOTE: Align shift levers in neutral position by
inserting .185" dia. gauge pin through holes in
levers as shown.
2. Loosen screw on each adjusting swivel clamp.
3. Set both shift levers on transmission in neutral
position.
4. Tighten screws on each adjusting swivel clamp
to 20 lb. ft.
5. Remove gauge pin and check complete shift
pattern.
LINKAGE ADJUSTMENT-FLOOR SHIFT (Fig. 7S-3
and Fig. 7B-4)
1. Position selector lever in neutral position.
2. Loosen trunnion jam nuts on transmission gear
shift control rods.
3. Place transmission lever and bracket assembly
in neutral position and install gauge pin as illustrated
in view A.