Pontiac tempest 1968 Service Manual page 443

7E-8
1968 P O N T I A C SERVICE MANUAL
NEUTRALIZE!*
S W I T C H
A D J U S T M E N T S C R E W
— BRACKET
FLOOR PAN
STARTER NEUTRALIZER SWITCH INSTALLATION
1. INSTALL S T A R T E R N E U T R A L I Z E R S W I T C H
T O B R A C K E T .
2. A D J U S T N E U T R A L I Z E R A D J U S T M E N T S C R E W
SO THAT START CIRCUIT IS "ON" IN
"NEUTRAL AND PARK" POSITIONS. AND IS
"OFF" IN "DRIVE AND REVERSE" POSITIONS
INSULATOR
VIEW A
Fig. 7 E - 6 Gearshift Controls (Console) - Pontiac
4. With O-ring seal on intake pipe, install pipe
and strainer assembly, attaching strainer to the
control valve assembly with its retainer bolt.
5. Thoroughly clean bottom pan.
6. Affix new gasket to bottom pan with petrolatum.
7. Install bottom pan with attaching screws and
torque to 12 lb. ft.
8. Pour approximately 7 1/2 pints of fluid into the
transmission (If the valve body has also been re­
moved, use 9 1/2 pints). After a complete overhaul,
approximately 19 pints are required. Be sure con­
tainer, spout or funnel i s clean.
9. Start engine and let idle (carburetor off fast
idle step). Place selector lever in P position and
apply hand brake.
10. With transmission hot (approximately 180-
190°F), add fluid to bring level to F U L L mark on
indicator.
With transmission at room temperature (70 °F),
add fluid to bring level to 1/4" below the ADD mark.
CAUTION: Do not overfill Foaming will result.
PRESSURE REGULATOR VALVE
REMOVAL
1. Remove bottom pan and strainer. Discard
gasket.