Pontiac tempest 1968 Service Manual page 489

7E-54
1968 P O N T I A C SERVICE M A N U A L
16. Install manual linkage as follows:
a. If necessary, install a new manual shaft seal
into transmission case using a 3/4 dia. rod to
seat the seal.
b. If removed, insert actuator rod into manual
detent lever from side opposite pin.
c. Install actuator rod plunger under parking
bracket and over parking pawl (Fig. 7E-149).
d. Install manual shaft through case and detent
lever.
e. Install detent retaining hex lock nut on manu­
al shaft and tighten (Fig. 7E-150).
f. Install retaining pin, indexing with groove
in manual shaft. Rotate transmission to vertical
position and remove J 21795.
• H i t
•••1
it,*-
Fig. 7E-151 Installing Direct Clutch
17. Install direct clutch and intermediate sprag
assembly. It will be necessary to twist housing to
allow sprag outer race to index with clutch drive
plates. Housing hub will bottom on sun gear shaft
(Fig. 7E-151).
NOTE: Removal of direct clutch drive and driven
plates may be helpful.
18. Install forward clutch hub to direct clutch
housing thrust washer on forward clutch hub. Retain
with petrolatum,
19. Install forward clutch and turbine shaft, in­
dexing direct clutch hub so end of mainshaft will
bottom on end of forward clutch hub. When forward
clutch is seated, it will be approximatley 1 1/4" from
pump face in case (Fig. 7E-152).
20. Install front pump.
21. Install all but one pump attaching bolt and
seal. Torque to 18 lb. ft.
NOTE: If turbine shaft can not be rotated as pump
is being pulled into place, forward or direct clutch
housing has not been properly installed to index
with all clutch plates. This condition must be cor­
rected before pump is pulled fully into place.
22. If necessary, install a new front seal, using
tool J 21359 to drive seal in place (Fig. 7E-153).
23. Check front unit end play as follows (Fig.
7E-154):
M A N U A L
SHAFT
KB
: N 1
i.
V?
R
4i
JAM
i l l !
Piiiii
• • M P
JH
IMB
F i g . 7E-150 Installing Detent Lever and Jam Nut to
Manual Shaft
F i g . 7E-152 Installing Forward Clutch and Turbine Shaft