Pontiac tempest 1968 Service Manual page 467

Table of Contents

Advertisement

7E-32
1968 P O N T I A C SERVICE MANUAL
b. Using i n s t a l l e r
J 21465-3
(front)
or
J 21465-2 (rear), install bushing.
14. Inspect oil ring grooves for damage or wear.
15. Inspect selective washer thrust face for wear
or damage.
16. Inspect pressure regulator and boost valve
for free operation.
17. Inspect pump cover for open 1/8" diameter
breather hole (Fig. 7E-76).
ASSEMBLY
OF OIL
PUMP
1. Install drive and driven pump gears into pump
body with alignment marks up (Fig. 7E-73).
NO TE:
Install drive gear with drive tangs up.
2. Protect stator shaft and install pump in vise.
3. Install spacer(s) if used, retainer and spring
into pressure regulator bore (Fig. 7E-69).
4. Install pressure regulator valve from opposite
end of bore, stem end first.
5. Install boost valve into bushing, stem end out,
and install both parts into pump cover by compres­
sing bushing against spring.
6. Install retaining snap ring.
7. Install pressure regulator valve bore plug and
retaining pin into opposite end of bore.
8. Install previously selected front unit selective
-1
* - - m ^
thrust washer (fiber) over pump cover delivery
sleeve.
9. Install two (2) hook type oil seal rings.
10. Assemble pump cover to pump body with at­
taching bolts.
NOTE:
Leave
bolts one turn loose at this
time.
11. Place pump aligning strap J 21368 over pump
body and cover and tighten tool (Fig. 7E-77).
12. Tighten pump cover bolts (18 lb. ft. torque).
13. Install and align pump to case gasket.
14. Install pump to case O-ring seal.
FORWARD CLUTCH
DISASSEMBLY
O F FORWARD
CLUTCH
1. Place forward clutch and turbine shaft in hole
in bench or holding fixture J 6116 and remove for­
ward clutch housing to direct clutch hub snap ring
(Fig. 7E-78).
2. Remove direct clutch hub.
3. Remove forward clutch hub and thrust washers
(Fig. 7E-79).
4. Remove five (5) radial grooved composition and
five (5) steel clutch plates.
Fig. 7E-77
Installing Pump Cover to Pump Body
Fig. 7E-78
Removing Forward Clutch Housing to Direct
Clutch Hub Snap Ring

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Firebird 1968

Table of Contents