Pontiac tempest 1968 Service Manual page 304

E N G I N E C O O L I N G A N D L U B R I C A T I O N
6A-7
REMOVE AND REPLACE ( 4 0 0 RAM-AIR ONLY)
1. Place new filter cartridge in engine compart­
ment near filter location,,
2. Raise vehicle „
3. Disconnect old filter cartridge using f i l t e r
wrench J 22775.
F i g . 6A-5 8 Cylinder O i l Filter Location
4. Hand tighten filter until gasket contacts filter
base, then tighten a further 2/3 of a turn using
J 22775 for convenience. Do not over-tighten.
5. Lower vehicle.
6. Remove old cartridge from engine compartment.
D R I V E B E L T S F O R P O N T I A C , T E M P E S T & F I R E B I R D E N G I N E
AND ACCESSORY DRIVE COMBINATIONS
Belt
Width
Belt Name
Borroughs Gauge Belt
Width
Belt Name
New Used
3/8"
15/32"
15/32"
3/8"
15/32"
Water Pump and Generator Belt (All 6 Cyl. and 8 C y l . ) . . . .
Power Steering Pump Belt (All 8 C y l . and 6 C y l . with A.C.) .
A . C . Compressor Belt (All 6 C y l . and 8 Cyl.)
120 Lbs.
145 L b s .
145 Lbs.
60 Lbs.
145 Lbs.
75 L b s .
105 Lbs.
105 Lbs.
50 Lbs.
105 L b s .