Pontiac tempest 1968 Service Manual page 468

T U R B O H Y D R A - M A T I C TRANSMISSION
7E
33
F O R W A R D
CLUTCH HUB
^^^^^^^^^^ * : 28
THRUST /
W A S H E R S -
f l f f p b
/
F O R W A R D CLUTC
H O U S I N G
Fig, 7 E - 7 9 Removing Forward Clutch Hub and
Thrust Washers
5. If necessary, place forward clutch and turbine
shaft in arbor press and remove turbine shaft (Fig.
7E-80).
6. Using J 4670 clutch spring compressor with
adaptor J 6129 and J 8765, compress spring retainer
and remove snap ring (Fig. 7E-81).
7. Remove snap ring, spring retainer and sixteen
(16) clutch release springs.
8. Remove forward clutch piston.
Fig. 7 E - 8 0 Removing Turbine Shaft from Forward
Clutch Housing
J 4670
RING
^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ ^
J 8765
" ^ ^ p i ^ ^ ^ ^ ^ ^ ^ ^ ^ ^ p
'^^lir^i
SPRING RETAINER
Fig. 7E-81 Removing Forward Clutch Spring
Retainer Snap Ring
9. Remove inner and outer clutch piston seals
(Fig. 7E-82).
10. Remove center piston seal from forward clutch
housing (Fig. 7E-83).
INSPECTION OF FORWARD CLUTCH
1. Inspect drive and driven clutch plates for signs
of burning, scoring or wear.
2. Inspect sixteen (16) springs for collapsed coils
or signs of distortion.
C L U T C H O U T - R S E A L
Fig. 7 E - 8 2 Removing Forward CI utch Piston Outer Seal