Pontiac tempest 1968 Service Manual page 485

7E-50
1968 P O N T I A C SERVICE MANUAL
: . THRUST W A S H E R
C O N S T A N T B L E E D
O R I F I C E P L U G
/
F i g . 7E-133 Installing Center Support to Reaction
Carrier Thrust Washer
17. Install roller clutch into reaction carrier outer
race (Fig. 7E-135).
18. Install phenolic center support to reaction
carrier thrust washer into recess in center support.
Retain with petrolatum (Fig. 7E-133).
19. Install case center support into reaction car­
rier and roller clutch assembly (Fig. 7E-136).
NOTE: With reaction carrier held, case support
should only turn counterclockwise.
20. Install J 21795 on gear unit to hold units in
place.
21. Install output shaft to case thrust washer tabs
in pockets and retain with petrolatum (Fig. 7E-137).
ROLLER CLUTCH
ASSEMBLY
REACTION
CARRIER
F i g . 7E-135 Installing Roller Clutch
ASSEMBLY OF UNITS INTO
TRANSMISSION CASE
NOTE: The first 3 steps can be omitted if the
parts involved were not removed on disassembly:
1. Install parking pawl, tooth toward inside of
case, and parking pawl shaft (Fig. 7E-138).
2. Install parking pawl shaft retainer clip (Fig.
7E-139).
3. Install new cup plug, using a 3/8" dia. rod, and
drive into transmission case until parking pawl shaft
bottoms on case rib (Fig. 7E-140).
4. Install parking pawl return spring, square end
hooked on pawl and other end on case (Fig. 7E-141).
CENTER SUPPORT
F i g . 7E-134 Installing Roller in Roller Clutch
F i g . 7 E - 1 3 6 Installing Center Support into Reaction
Carrier and Roller Clutch