V-8 E N G I N E
6-41
BOXED FRAME
FRAME
w
VIEW " D
f
CROSS-MEMBER
VIEW " C "
STARTING
MOTOR
SUPPORT
SUPPORT
BRACKET
VIEW " B "
VIEW " A '
Fig. 6-73
Pontiac Engine Insulators
ENGINE
INSULA TORS—REM
O VE AND
REPLACE
TEMPEST
(Fig. 6-75)
and FIREBIRD
(Fig.
6-76)
FRONT INSULATORS
1. Raise hood and, using J 22603 engine lifting
tool, F i g . 6-74,
take weight of engine off front
insulators.
NOTE:
Disconnect
battery ground strap
before
raising
engine.
When engine is raised, the
start
ing
motor
solenoid
terminals
may contact
the
steering
gear
which could energize
the
starting
motor if ground cable is not
disconnected.
2. Loosen rear insulator by removing crossmem
ber to insulator bolts and raise rear of engine.
3. Remove bolts which fasten front insulators to
frame bracket.
4. Raise engine just clear of insulators.
5. Remove insulator to engine bolts and remove
insulators.
6. Position new insulators against engine and in
stall attaching bolts and washers. Tighten to 70 lb.
ft. torque.
7. Lower engine.
8. Install frame bracket to insulator bolts with
lockwashers and tighten to 30 lb. ft. torque.
/
22603-4
22603
Fig. 6 - 7 4
Engine Lifting Tool Instal led—Pontiac and Tempest