T U R B O H Y D R A - M A T I C TRANSMISSION
7E-19
Fig. 7 E - 3 6
Removing Parking Bracket
F i g . 7E-38
Removing Parking Shaft Retaining Spring
NOTE:
The following
steps are to be
completed
only if one or more of the parts involved
require
replacement:
g. Remove parking pawl shaft retainer (Fig.
7E-38).
h. Remove parking pawl shaft cup plug by in
serting a screwdriver between the parking pawl
shaft and the transmission case rib (Fig. 7E-39).
i . Remove parking pawl shaft and parking pawl
(Fig. 7E-40).
8. Remove front band (Fig. 7E-41).
9. Remove sun gear shaft (Fig. 7E-42).
Fig. 7 E - 3 7
Removing Parking Pawl Return Spring
Check Rear End Play As Follows:
a. Install J 21904 into an extension housing at
taching bolt hole (Fig. 7E-43).
b. Mount dial indicator J 8001 on rod and index
with end of output shaft.
c. Move output shaft in and out to read end
play. End play should be from .003" to .019". Se
lective washer controlling this end play is steel
washer having 3 lugs. It is located between thrust
washer and rear face of transmission case.
If a different washer thickness is required to bring
end play within specification, it can be selected from
the following chart:
Fig. 7 E - 3 9
Removing Parking Pawl Shaft Cup