CHASSIS ELECTRICAL SERVICE
12-37
BRUSH PLATE AND
MOUNTING BRACKET
FRAME AND
FIELD ASSEMBLY
SPRING
WASHERS
..•*'$»
FLAT WASHERS
ARMATURE
END PLATE
THRUST
PLUG
F i g . 12-42
Motor Exploded View—Tempest
1. Follow steps 1 thru 4(a) under gear box dis
assembly.
2. Remove bolts, then remove gear box cover from
frame and field assembly.
3. Release brush spring pressure against brushes
as shown in Fig. 12-44.
G E A R CASE G R O O V E S
C R A N K A R M G R O O V E S
4. Move brushes away from armature and slide
armature out of frame and field assembly. Pull end
plate assembly off armature.
CAUTION:
Use care to insure that small
thrust
plug at end of armature
shaft does not get lost.
5. Remove end play adjusting washers.
To reassemble motor, reverse steps 1 thru 4 as
required.
TEMPEST AND FIREBIRD LUBRICATION
Armature shafts and bearings: Light grade ma
chine oil.
BRUSH HOLDER
REMOVE BRUSH SPRING FROM SLOT
AND PLACE IT IN GROOVE AS SHOWN
F i g . 12-43
Crank Arm in Park Position—Tempest
and Firebird
F i g . 12-44
Brush Spring Tempest and Firebird