Table of Contents
Advertisement
7F-28
1968 P O N T I A C SERVICE MANUAL
P A R K I N G L O C K
S P R I N G
P A R K I N G
L O C K P A W L
P A R K I N G L O C K
P A W L S H A F T
F i g . 7 F - 8 3
installing Parking Lock Pawl Shaft
N U T ,
O U T E R R A N G E
S E L E C T O R
L E V E R
Mm
I N N E R P A R K L O C K
A N D R A N G E
S E L E C T O R A S S Y .
F i g . 7 F - 8 4
Installing Inner Park Lock and Range Selector
RANGE SELECTOR
SHAFT R E T A I N E R
DRIFT
mT^mm
• H U H
P A UK K K .
Figo 7 F - 8 5 Installing Range Selector Shaft Retainer
F i g . 7F-86
Installing Parking Lock Bracket
gaskets
and other joints. Use a reliable torque
wrench to tighten all bolts and nuts to specified
torque.
INSTALLATION
OF RANGE
SELECTOR
LEVER,
SHAFT,
AND
PARKING
LOCK
ACTUATOR
1. Hold parking lock pawl and spring in position
and retain with parking lock pawl shaft (Fig. 7F-83).
2. Install range selector shaft into case with a
twisting motion.
3. Install inner park lock and range selector as
sembly on range selector shaft and secure with nut
(Fig. 7F-84).
NOTE:
Make
certain
that shorter
end of outer
lever is to bottom of
transmission.
4. Install range selector shaft retainer (Fig. 7F-85).
5. Install parking lock bracket in case and tighten
bolts to 10 lb. ft. torque (Fig. 7F-86).
INSTALLATION
OF REVERSE
PISTON
AND
CLUTCH
1. Install cushion ring if it was removed (Fig.
7F-88) and with transmission in vertical position,
install reverse clutch piston into case, making cer
tain it bottoms in case.
2. Install clutch piston return springs.
3. Position piston return seat on piston return
springs. Place snap ring in position on return seat
so that ring can be easily installed when seat is
compressed with tool.
Hide quick links:
Advertisement
Chapters
Table of Contents
