T U R B O H Y D R A - M A T I C TRANSMISSION
7E-31
Fig. 7E-73
Installing Pump Drive G e a r
4. Check oil passages (Fig, 7E-75).
5. Check for damaged cover bolt attaching threads.
6. Check for overall flatness of pump body face.
7. Check bushing for scores or nicks. If replace
ment is necessary, proceed as follows:
a. Using tool J 21465-17, remove bushing.
b. From gear pocket side of pump and using
J 21465-17,
install new bushing flush to .010".
8. Inspect pump attaching bolt seals for damage,
replace if necessary.
9. Inspect pump cover face for overall flatness.
VENT
CONVERTER
COOLER
RETURN
_ . T O
COOLER
LINE
,
MODULATOR OR
INTERMEDIATE
DRIVE
Fig. 7E-75
Pump Body O i l Passages
10. Check for scores or chips in pressure regu
lator bore.
11. Check that all passages
are open and not
inter-connected (Fig. 7E-76).
12. Check for scoring and damage at pump gear-
face.
13. Inspect stator shaft for damaged splines or
scored bushing. If replacement of bushings is nec
essary, proceed as follows:
a. Thread J 21465-15 into stator shaft bushing.
Thread slide hammer J 2619 into remover. Clamp
slide hammer handle into vise. Grasp stator shaft
and remove.
DRIVE
REVERSE
EXHAUST
,
,
LINE
M O D U L A T O R O R
INTERMEDIATE
'''•IllP
INTAKE-
TO
" C O O L E R
C O O L E R
RETURN
C O N V E R T E R
^
> \
\
BREATHER
H O L E
- L U B E
LINE
VENT
Fig. 7 E - 7 4
Checking Pump Body Face to
Gear Face Clearance
Fig. 7E-76
Pump Cover O i l Passages