1A-36
1968 P O N T I A C SERVICE M A N U A L
-CENTER AIR DUCT
Fig.
1 A - 5 2 A i r System Body Interior - Tempest
10. Remove core tube seal and then core from
casting.
NOTE;
Be sure the core to case sealer is intact
before replacing
core.
Replace
with new sealer if
necessary.
11. To replace reverse removal procedure.
CAM
ASSEMBLY—TEMPERATURE
DOOR-ALL
1. Remove glove compartment.
2. Scribe
alignment marks
on case for cam
placement.
3. Remove control cable.
4. Remove cam hold down screws.
5. Remove cam.
6. To replace reverse removal procedure.
7. Adjust cable.
TEMPERATURE
CABLE
REMOVE
OR
ADJUST
(Fig.
I A - 5 4 )
PONTIAC
1. Remove cold air duct.
2. Disconnect cable at control panel.
3. Remove glove box.
4. Disconnect cable at cam assembly.
5. To replace reverse removal procedure.