Pontiac tempest 1968 Service Manual page 511

7F-10
1968 P O N T I A C SERVICE MANUAL
6. Install oil strainer (make certain grommet Is In
good condition) and tighten retaining bolt to 10 lb. ft,
torque. Install oil pan, using a new gasket. Tighten
oil pan bolts to 12 lb. ft. torque.
VALVE BODY
REMOVAL
1. Remove oil pan and gasket.
2. Remove oil strainer retaining bolt and remove
strainer assembly (Fig. 7F-18) using a twisting mo­
tion. Discard oil seal.
3. Disconnect solenoid connector from case.
(Fig. 7F-25).
4. Remove detent spring from valve body (Fig.
7F-25).
5. Remove remaining valve body bolts and hold
valve body in position.
F i g . 7 F - 1 8 Transmission - O i l Pan Removed
DOWNSHIFT SOLENOID REPLACEMENT
1. Remove oil pan, gasket and oil strainer.
2. Disconnect solenoid connector from case con­
nector (Fig. 7F-25).
3. Remove solenoid attaching bolts. Remove sole­
noid and gasket.
4. Install new gasket on solenoid so that gasket
notch will face bottom of valve body.
5. Install solenoid on valve body and secure con­
nector to case connector.
I N N E R P A R K L O C K
A N D R A N G E S E L E C T O R
L E V E R ^
. „J-J-
M A N U A L C O N T R O L
, - * j V A L V E L I N K
6. Disengage manual control valve link from park
lock and range selector inner lever by rotating valve
body (Fig. 7F-19).
7. Remove valve body. Remove manual control
valve and link from valve body.
8. Remove oil channel support plate (Fig. 7F-25),
valve body plate and plate to case gasket.
DISASSEMBLY
1. Remove downshift solenoid, gasket, spring and
detent valve (Fig. 5F-20).
2. Depress shift control valve sleeve and remove
retaining pin by turning valve body over so pin can
fall free (Fig. 7F-21). Remove shift control valve
sleeve, shift control valve, spring, washer and shift
valve.
r - S P R I N G
/
V A L V E
G A S K E T
S O L E N O I D
B O L T S
D E T E N T -
f
* ? ^ \ > > ^
\ / A
i \ / c - : * -
F i g . 7 F - 1 9 Disengaging Manual Control V a l v e Link
F i g . 7 F - 2 0 Downshift Solenoid and Detent Valve