Installation Of Transmission Assembly - Pontiac tempest 1968 Service Manual

T U R B O 11YDRA-MATIC
TRANSMISSION
7E-59
DETENT ROLLER AND
SPRING ASSEMBLY
mm
Fig. 7E-167 Installing Detent Roller and Spring Assembly
4. Install modulator retainer and attaching bolt.
Torque bolt to 18 lb. ft.
INSTALLATION OF GOVERNOR
1. Install governor into case (Fig. 7E-169).
2. Attach governor cover and new gasket with
four (4) attaching bolts. Torque bolts to 18 lb. ft.
INSTALLATION OF SPEEDOMETER DRIVEN GEAR
1. Install speedometer driven gear (Fig. 7E-170).
2. Install speedometer driven gear retainer and
attaching bolts.
MODULATOR VALVE
O - RING SEAL
•
/
VACUUM MODULATOR
Fig. 7 E - 1 69 Installing Governor
INSTALLATION OF CONVERTER ASSEMBLY
With the transmission in cradle or portable jack,
install the converter assembly into the pump assem­
bly, making certain that the converter hub drive
slots are fully engaged with the pump drive gear
tangs and the converter installed fully towards the
rear of the transmission.
INSTALLATION OF TRANSMISSION ASSEMBLY
Reverse the procedure for transmission removal
as stated on page 7E-12.
S P E E D O M E T E R
D R I V E N GEAR
•0-RGES3G S E A L
F i g . 7E-168 Installing Vacuum Modulator and V a l v e
F i g . 7E-170 Installing Speedometer Drive G e a r and Sleeve