Pontiac tempest 1968 Service Manual page 65

1A-38
1968 P O N T I A C SERVICE M A N U A L
C A B L E SUPPORT
G A U G E P I N
3 / 1 6 D I A .
C A M P I N
F i g . 1 A - 5 4 Temperature Cable - Adjustment
4. Disconnect cable at cam assembly.
5. To replace reverse removal procedure.
TO ADJUST (Pig. 1A-55)
1. Remove glove box.
2. Place Temp lever In full cold or "Cooler"
position.
3. Adjust turnbuckle as necessary to allow 3/16"
gauge pin to pass freely through heater cam and cam
bracket index holes.
4. With gauge pin In place, adjust turnbuckle to
move lever against lower end of slot i n control
panel, then turn turnbuckle i n opposite direction to
move control lever 1/8" to 3/16" away from end of
slot.
5. Remove gauge pin.
6. Move Temp lever to full heat or " W a r m e r "
position, then back to off.
7 . Gauge pin must f i t freely through index holes.
8. Replace glove box.
FIREBIRD
1. Remove control panel from dash.
2. Disconnect cable at control panel.
GREEN PAINT MARK
X
NOTE: C O N N E C T O R S MUST BE
INSTALLED T O FIT TIGHTLY O N
VACUUM SWITCH PORTS.
VIEW A
F i g . 1 A - 5 5 Control System - Pontiac