Pontiac tempest 1968 Service Manual page 469

7E-34
1968 P O N T I A C SERVICE MANUAL
FORWARD CLUTCH HOUSING
mJm
CLUTCH CENTER SEAL
Fig. 7 E - 8 3 Removing Forward Clutch Center Seal
3. Inspect clutch hubs for worn splines, proper
lubrication holes, thrust faces.
4. Inspect piston for cracks.
5. Inspect clutch housing for wear, scoring, open
oil passages and free operation of ball check.
6. Inspect turbine shaft:
a. Inspect for open lubrication passages at
each end.
b. Inspect splines for damage.
c. Inspect ground bushing journals for damage.
d. Inspect shaft for cracks or distortion.
NOTE: Turbine shaft and clutch housing are
serviced separately. Shaft may be removed from
housing by using a suitable size bolt in an arbor
press (Fig. 7E-80).
ASSEMBLY OF FORWARD CLUTCH
NOTE: Apply automatic transmission oil to all
seals and clutch plates before re-assembly.
1. Place new inner and outer oil seals on clutch
piston, lips face away from spring pockets (Fig.
7E-82).
FORWARD CLUTCH
ASSEMBLY
WAVED
STEEL
PLATE
FLAT STEEL
PLATES (4)
/
COMPOSITION
PLATES (5)
FORWARD
CLUTCH H U E
DIRECT
CLUTCH HUB
SNAP
RING
• S i
THRUST
WASHERS
Fig. 7 E - 8 4 Exploded View of Forward Clutch