Pontiac tempest 1968 Service Manual page 487

7E-52
1968 P O N T I A C SERVICE MANUAL
SNAP RING
I
I
F i g . 7E-142 Installing Rear Band
NOTE: Dip washer in transmission oil before
installation.
8. Install complete gear unit assembly Into case,
using tool J 21795 (Fig. 7E-143) and making certain
center support bolt hole is properly aligned with
hole in case.
9. Install center support to case retaining snap
ring, with bevel side up and locating gap adja­
cent to band anchor pin. Make certain ring i s prop­
erly seated in case (Fig. 7E-144).
10. Install case to center support locating screw
F i g . 7 E - 1 4 4 Installing Center Support to Case Snap Ring
and torque to 5 lb. ft. Lubricate and install case to
center support bolt and torque to 22 lb. ft. Remove
locating screw and keep for use on future rebuild
jobs to properly locate the case center support (Fig.
7E-145).
11. Lubricate with transmission oil and install
three (3) steel and three (3) composition intermediate
clutch plates. Start with waved steel, alternate
plates (Fig. 7E-146).
12. Install intermediate clutch backing plate, ridge
up
c
13. Install backing plate to case snap ring, locating
gap opposite band anchor pin.
14. Check rear end play as follows:
a. Install J 21904 with 3/8" adapter into an
extension housing attaching bolt hole (Fig. 7 E -
147).
; CENTER SUPPORT BOLT 1 '
i L O C A T I N G S C R E W !
F i g
0
7 E - 1 4 3 Installing Center Support and G e a r Unit
F i g . 7E-145 Install Center Support Bolt