Pontiac tempest 1968 Service Manual page 456

T U R B O H Y D R A - M A T I C TRANSMISSION
7E-21
*****
^ C E N T E R SUPPORT BOLT
1
X
Fig. 7 E - 4 4 Removing Center Support Bolt
13. Remove center support to case retaining snap
ring (Fig. 7E-46).
14. Remove entire gear unit assembly by lifting
with gear assembly installing and removing tool
J 21795 with J 6125-1 slide hammer (Fig. 7E-47).
15. Remove output shaft to case thrust washer
from rear of output shaft or from inside of case.
16. Place gear unit assembly, with output shaft
facing down, in hole in work bench or holding fix­
tures J 6116 and J 21364.
17. Remove rear unit selective washer from
transmission case (Fig. 7E-48).
18. Remove rear band assembly (Fig. 7E-49).
?
B A C K I N G PLATE ^
C O M P O S ITS O N PLATES (3)
STEEL PLATES ( 3 ) *
SNAP
RING
A-
Fig. 7E-46 Removing Center Support to Case Snap Ring
DISASSEMBLY OF GEAR UNIT
1. Remove case center support assembly (Fig.
7E-50).
2. Remove center support to reaction carrier
phenolic thrust washer (Fig. 7E-51).
3. Remove center support to sun gear races and
thrust bearing.
J 6125-1
J 2 1 7 9 5
Fig. 7 E - 4 5 Removing Intermediate Backing
Plate and Clutch Plates
Fig. 7 E - 4 7 Removing Case Center Support and
G e a r Unit from Case