1A-44
1968 P O N T I A C S E R V I C E MANUAL
DEFROSTER
DUCT
PONTIAC OR T E M P E S T
1. Remove cold air duct.
2. Remove instrument panel face pad.
3. Remove glove compartment.
4. Remove radio.
5. Remove duct retaining screws.
6. Remove duct.
7. To replace reverse above procedure.
FIREBIRD
1. Remove cold air duct.
2. Remove glove compartment, ash tray bracket
and radio.
3. Remove duct retaining screws.
4. Remove heater case assembly.
5. Remove duct.
6. To replace, reverse removal procedure.
OUTLET
NOZZLE
RIGHT
OR
LEFT
PONTIAC
1. Remove
instrument panel face pad.
If right
side, remove cold air duct.
2. Remove nozzle retaining screws.
3. Slide duct adapter from nozzle.
4. Remove nozzle.
T E M P E S T
1. Remove upper retaining screws.
2. Remove lower retaining screws.
3. Separate and remove nozzle.
4. To replace, reverse removal procedure.
NOTE:
The rear half of the bezel is riveted to in
strument panel face pad. Should it become neces
sary to replace the bezel, use pop rivets and not
screws.
FIREBIRD
1. Remove two exterior retaining screws.
2. Pull assembly from dash.
3. Remove flex hose from rear of nozzle.
4. Separate components.
5. To replace, reverse removal procedure.
UPPER
AIR
OUTLET
PONTIAC
1. Remove instrument panel face pad.
2. Remove outlet retaining screws.
3. Bend d u c t
r e a r w a r d
and remove
outlet
assembly.
4. To replace, reverse removal procedure.
T E M P E S T
1. Remove instrument panel face pad.
2. Remove outlet retaining screws.
3. R e m o v e
outlet
a s s e m b l y
and
separate
components.
4. To replace, reverse removal procedure.
FIREBIRD
1. Remove instrument panel trim plate.
2. Remove screws retaining outlet to dash.
3. Remove cold air duct.
4. Remove glove compartment.
5. Pull assembly down from dash area and sepa
rate components.
6. To replace, reverse removal procedure.
AMBIENT
SWITCH
PONTIAC
1. Disconnect A / C relay connectors.
2. Remove relay bracket.
3. Remove ambient switch connector.