Ford 2003 Mustang Workshop Manual page 4050

Was the continuous DTC retrieved during Step H1 an
intermittent fault?
H6 CHECK FOR ADDITIONAL DTCs
Refer to the continuous DTCs recorded during Step H1.
Were any continuous DTCs retrieved during Step H1.
Pinpoint Test I: LFC 33/DTC B1933 — Passenger Air Bag Circuit Resistance High
Normal Operation
The restraints control module (RCM) monitors the resistance of the passenger air bag ignitor by
measuring the resistance between pins 6 and 7. If the RCM detects high resistance between these
pins, it will store a diagnostic trouble code (DTC) B1933 in memory and flash a lamp fault code (LFC)
33 (or higher priority code if one exists) on the air bag indicator.
Possible Causes
A passenger air bag high resistance can be caused by:
CHECK for causes
of intermittent high
resistance on circuit
614 (GY/OG),
circuit 615
(GY/WH), and the
clockspring
assembly. Attempt
to recreate the hard
fault by flexing the
wire harness and
cycling the ignition
key frequently.
REPAIR any
intermittent
concerns found.
GO to H6 .
No
GO to H6 .
Yes
Do not clear any
DTCs until all DTCs
have been
resolved. GO to the
Restraints Control
Module (RCM)
Diagnostic Trouble
Code (DTC) Priority
Table in this section
for pinpoint test
direction.
No
RECONNECT the
system.
REACTIVATE the
system. PROVE
OUT the system.
REFER to Air Bag
Supplemental
Restraint System
(SRS) in this
section. CLEAR all
DTCs.