Ford 2003 Mustang Workshop Manual page 3997

SECTION 501-20A: Safety Belt System
REMOVAL AND INSTALLATION
Retractor —Front Seat Safety Belt, Convertible
Special Tool(s)
Removal
1. Remove the quarter trim panel (31012). For additional information, refer to
2. Remove the nut and bolts and safety belt retractor.
Installation
NOTE: Make sure the safety belt is not twisted.
1. The shipping clip must remain attached prior to the installation of the retractor into the vehicle.
The clip must be removed after the retractor is installed.
2. Position the safety belt retractor. Install the nut and bolts.
Torx Bit, Safety Belt Bolt
501-010 (T77L-2100-A)
2003 Mustang Workshop Manual
Section 501-05 .