Ricoh D146 Service Manual page 1134

Job End Area
045
Coefficient:YMC
046 Job End Vb Coefficient:YMC
047 Job End Length:YMC
3550 [Refresh Mode]
TC Adj. Consume(Upp Limit)
081
Sets consume counts (upper limit) for toner density adjusting Pro-Con.
3552 [Blade damage prevention mode]
Execution Temp. Threshold
001
Sets temperature threshold for creating blade Tear off prevent pattern.
3553 [Transfer belt cleaning]
TransferIdleTime
Temperature:H
001
Prevents poor cleaning by racing the image transfer when going over
temperature threshold t2 and poor cleaning occurred right after Pro-Con/MUSIC
etc... adjust pattern was entered.
TransferIdleTime
Temperature:M
002
Prevents poor cleaning by racing the image transfer when between temperature
threshold t1to t2 and poor cleaning occurred right after Pro-Con/MUSIC etc...
adjust pattern was entered.
TransferIdleTime
Temperature:L
003
Prevents poor cleaning by racing the image transfer when smaller than
temperature threshold t1 and poor cleaning occurred right after Pro-Con/MUSIC
etc... adjust pattern was entered.
TransferIdleTime
004
Temperature:L:ON
System Maintenance Section
*ENG [0.1 to 25.5 / 1.0 / 0.1/step]
*ENG [0 to 100 / 40 / 1%/step]
*ENG [0 to 255 / 25 / 1mm/step]
*ENG [0 to 255 / 20 / 1times/step]
*ENG [0 to 50 / 40 / 1deg/step]
[0.0 to 3.0 / 0.0 /
*ENG
0.1revolutions/step]
[0.0 to 3.0 / 0.0 /
*ENG
0.1revolutions/step]
[0.0 to 3.0 / 0.0 /
*ENG
0.1revolutions/step]
[0.0 to 3.0 / 0.0 /
*ENG
0.1revolutions/step]
2-415
Main SP Tables-3
D146/D147/D148/D149/D150