Ricoh D146 Service Manual page 1520

If a paper size or type mismatch occurs during the printing of multiple
copies, only a single copy is output by default. Using this BitSw, the
device can be configured to print all copies even if a paper mismatch
occurs.
bit 2 Prevent SDK applications from altering
the contents of a job.
If this BitSw is enabled, SDK applications will not be able to alter print
data. This is achieved by preventing SDK applications from accessing a
module called the "GPS Filter".
Note: The main purpose of this BitSw is for troubleshooting the effects of
SDK applications on data.
bit 3 [PS] PS Criteria
Change the number of PS criterion used by the PS interpereter to
determine whether a job is PS data or not.
bit 4
Increase max. number of stored jobs.
Changes the maximum number of jobs that can be stored on the HDD.
The default (disabled) is 100. If this is enabled, the max. will be raised to
750 or 1000 depending on the model.
bit 5 DFU
bit 6 Method for determining the image rotation
for the edge to bind on.
If enabled, the image rotation will be performed as they were in the
specifications of older models for the binding of pages of mixed
orientation jobs.
The old models are below:
- PCL: Pre-04A models
- PS/PDF/RPCS:Pre-05S models
bit 7
Letterhead mode printing
System Maintenance Section
Disabled
Pattern3
Disabled
(100)
-
Disabled
Disabled
2-801 D146/D147/D148/D149/D150
Printer SP Mode
Enabled
Pattern1
Enabled
(750)
-
Enabled
Enabled
(Duplex)