IE-78K0-NS-P04, IE-1615-NS-EM4
<2> Prepare the IE-78K0-NS-P04 Emulation Board.
<3> Remove the parts holder inserted in the socket (marked "X2") on the IE-78K0-NS-P04 Emulation
Board.
<4> Connect the parts holder (from <1> above) to the socket (X2) from which the part holder was
removed. Check the pin 1 mark to make sure the board is mounted in the correct direction.
<5> Make sure that the parts board mounted in the X2 socket on the emulation board is wired as shown
in Figure 3-10 above.
<6> Install the IE-78K0-NS-P04 Emulation Board and the IE-1615-NS-EM4 Probe Board in the IE-78K0-
NS-A.
The above steps configure a circuit and enable clock output to be supplied from the mounted oscillator
to the emulation device.
3
CA
12
Remark:
The sections enclosed in broken lines indicate parts that are attached to the parts holder.
36
Figure 3-14: IE-78K0-NS-A side (Emulation Device)
10 MΩ
6
HCU04
HCU04
9
5
Rx
X
10
4
11
13
CB
2
IE-78K0-NS-A side
(Emulation device)
8
X1
X1
A
Y
B
VHC157