Kyocera TASKalfa 620 Service Manual page 55

Maintenance
item No.
Setting the printing area for folio paper
U035
Description
Changes the printing area for copying on folio paper.
Purpose
To prevent cropped images on the trailing edge or left/right side of copy paper by setting the actual printing
area for folio paper.
Method
Press the start key. The setting screen is displayed.
Setting
1. Select the item to be set. The selected item is displayed in reverse.
2. Change the setting value using the cursor up/down keys.
Display
LENGTH DATA
WIDTH DATA
3. Press the start key. The value is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Checking the operation of the fan motors
U037
Description
Drives the fan motors.
Description
To check the operation of the fan motors.
Method
1. Press the start key. The screen for selecting an item is displayed.
2. Select the item to operate. The selected item is displayed in reverse and starts driving the fan motor.
Display
FEED SHIFT FAN
DLP FAN R
DLP FAN F
COOLING FAN
DUP FAN
IMAGE FAN
LSU FAN
LAMP FAN
3. To stop the motor, press the stop/clear key.
Completion
Press the stop/clear key when the motor stops. The screen for selecting a maintenance item No. is displayed.
Description
Setting Setting range
Length 330 to 356 (mm)
Width 200 to 220 (mm)
Operation
The feedshift fan motor (FSFM) is turned ON.
The developing duct fan motor (DEVDFM) is turned ON.
Developing fan motor 1 (DEVFM1) and 2 (DEVFM2) are turned ON.
Cooling fan motor 1 (CFM1), cooling fan motor 2 (CFM2), cooling fan
motor 3 (CFM3), cooling fan motor 4 (CFM4), PWB fan motor 1
(PWBFM1) and PWB fan motor 2 (PWBFM2) are turned ON.
The duplex fan motor (DUPFM) is turned ON.
The image formation fan motor (IFFM) is turned ON.
The LSU fan motor (LSUFM) is turned ON.
The lamp fan motor (LFM) is turned ON.
2KN/2KP
Initial setting
330
210
1-3-17