Kyocera TASKalfa 620 Service Manual page 272

2KN/2KP
5. Remove the transfer belt from the transfer
unit.
6. Replace the transfer belt and attach the belt
to the transfer unit.
* After installing the transfer belt, rotate the
transfer belt roller 2 or 3 times, it turns, and
check that the belt does not been stranded
to the belt holder front and rear.
7. Refit the front transfer guide and spring to
the transfer unit.
8. Check if the contact between the transfer
ground roller and grounding plate spring is
correct.
9. Refit the transfer unit.
1-5-52
Transfer belt
Belt holder
Transfer ground roller
Transfer unit
Figure 1-5-107
Transfer belt
Figure 1-5-108
Grounding plate spring
Figure 1-5-109
Tranfer belt
roller
Belt holder