Detaching And Refitting The Transfer Belt - Kyocera TASKalfa 620 Service Manual

(2) Detaching and refitting the transfer belt

Follow the procedure below to replace the transfer belt.
Caution:
When handling the transfer belt, hold the both end of the transfer belt (within 10 mm), never touch the surface with bare
hand.
Be careful not so as to adhere grease on the surface of the transfer belt.
Procedure
1. Remove the transfer unit (see page 1-5-49).
2. Rotate the transfer front guide and fit the
angle of the end of the inserted shaft as
shown in the figure, and then remove the
transfer front guide from the transfer unit.
3. Remove the spring from the transfer unit.
4. Remove each screw at front and rear trans-
fer unit, and rotate the transfer belt roller as
shown in the figure.
Inserted shaft
Spring
Figure 1-5-105
Transfer belt roller
Figure 1-5-106
2KN/2KP
Transfer unit
Front transfer guide
1-5-51