Table of Contents
Advertisement
Add Devices
This section describes input connections and how to connect devices to the projector.
Connect devices to the projector
1. To access the communication ports, remove the access panel.
2. Route all cables along the channels located on the bottom of the projector and up through the
opening in the frame to the communication port.
3. Replace the access panel to ensure server and source connections remain secure.
Input signal devices are connected are connected to the video option cards and communication
devices are connected at the MCPU panel.
Connect a video source via DisplayPort
The Twin DisplayPort Input Card (TDPIC) accepts digital video data from the DisplayPort sources.
Various input configurations are supported.
Input
Configuration
Four-Port
Enables connection of four DisplayPort cables to two TDPIC cards
(using the 1-IN and 2-IN inputs of two cards in slots 1 and 2, or in
slots 3 and 4). Each DisplayPort input supplies one quadrant of a 4K
input image. This configuration supports high resolution and high
frame rate input video streams, including both 2D and 3D direct
inputs.
Four-Port, Dual-
May be used for Dual-Input 3D configurations. For information on
Input 3D
the video quadrant mapping for the TDPIC four-point input
configuration, see
page 31.
D4KLH60/Mirage 4KLH User Manual
020-101375-02 Rev. 1 (06-2015)
SLOT 1
SLOT 3
Description
Four-port input video quadrant mappings
SLOT 2
SLOT 4
Requirements
Two TDPIC cards
Four TDPIC cards
on
Add Devices
28
Advertisement
Table of Contents
