3D Input Video Configurations; Connect Devices To The Projector - Christie D4KLH60 Mirage 4KLH Installation Manual

3D input video configurations

The stereo 3D input video stream may be supplied from the video server to the projector in two
configurations: Direct-Input 3D or Dual-Input 3D.
Configuration
Direct-Input 3D
Dual-Input 3D

Connect devices to the projector

1. To access the communication ports, remove the access panel.
2. Route all cables along the channels located on the bottom of the projector and up through the
opening in the frame to the communication port.
3. Replace the access panel to ensure server and source connections remain secure.
Input signal devices are connected are connected to the video option cards and communication
devices are connected at the MCPU panel.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
Description
In this configuration a single video stream is provided by the video server, with the left
eye and right eye frames supplied as alternate frames within the video stream. A 3D
Input Sync may be used to identify the left eye frames.
The Direct-Input 3D video stream may be supplied by either a Four-Port input video
configuration (such as four cables each supplying one quadrant of the image) or an One-
Port input video configuration (such as one cable supplying the entire frame).
In this configuration two video streams are provided by the video server, with the left eye
supplied by one stream and the right eye supplied by the other. The video streams are
frame locked and supplied concurrently.
The Dual-Input 3D video streams may be supplied by either two Four-Port input video
configurations (such as four cables each supplying one quadrant of the image for each
eye, with a total of eight cables) or two One-Port input video configurations (such as one
cable supplying the entire frame for each eye, with a total of two cables).
SLOT 1
SLOT 3
SLOT 2
SLOT 4
Installation
45