Installing The Toner Cartridge; Installing And Replacing The Hard Disk; Installing Other Options; Mounting The Accessory Parts - Konica Minolta bizhub 287 Service Manual

Security Function Ver. 1.02 Mar. 2016
3.1.3

Installing the toner cartridge

Since a toner cartridge is not supplied with the machine, purchase one separately.
1. Shake the toner cartridge up and down and left to right 5 to 10 times respectively.
Shake the cartridge adequately. Otherwise, it may cause trouble.
2. Insert the toner cartridge into the machine. Make sure that the blue label position of the
toner cartridge is matched with the one of the machine side.
3. Push the toner cartridge all the way in and rotate it clockwise to lock it. Make sure that
the toner cartridge is pushed all the way in.
4. Close the front door.
3.1.4

Installing and replacing the hard disk

1. Make sure that the package has not been previously unpacked.
Pay attention to the following.
• If the security seal is peeled off.
• If the PP tape on the package has been peeled off or re-stuck.
2. Take out the hard disk from the package.
3. Make sure that the following information is correct.
• Product Name: HD-522
• Part Number: A878WY1
4. See the service manual for methods of installation and replacement.
After the main power switch is turned ON, check if access can be made normally.
3.1.5

Installing other options

See the "Installation procedures" of the installation manual for each option.
3.1.6

Mounting the accessory parts

1. Set the stylus pen.
2. Attach the supplied connector cover to the machine. (One supplied screw)
3.1.7

Connecting the power cord

1. Connect the power cord. This may not be performed depending on the applicable mar-
keting area.
2. Plug the power cord into the power outlet.
3.1.8

Starting the machine

1. Turn ON the power switch on the right side of the main body.
3.1.9

Make the necessary settings

• Date & Time Setting/Time Zone Setting ([Service Mode] → [Date & Time Setting/Time
Zone Setting screen (To display the Date & Time Setting/Time Zone Setting screen,
press Stop → 1 → 1 → 4 → 4 → Clear on the control panel)])
• Serial number input ([Service Mode] → [System 1] → [Serial Number])
• Unit change ([Service Mode] → [System 2] → [Unit Change])
3. Installation of the machine and steps to be
performed before operation
2