Connecting Cables; Network Setting - Konica Minolta bizhub C352 Installation Manual

XXII. Check through Test Print
Make operation checks using "Setting Information
Print."
1. Select the function to be used as follows:
Utility/Counter → User Setting → Printer Setting
→ Print Reports.
The types of the test prints that can be printed will
be displayed.
2. Touch "Configuration Page."
3. Touch A4 size and press the start key.
Check that the machine produces the corre-
sponding printed page.
4. Touch "Close" twice and then "Exit."
XXIII. Connecting Cables
1. Using the network cable (category 5), make cable
connections between the network device (HUB)
and the machine.
Ethernet 10BaseT/100BaseTX Networkport
LED1
LED2
2. Check LEDs for lighting conditions.
LED1:
Should light up steadily if the link network con-
nection has been made.
LED2:
Should blink according to the communications
status of the ACT network.
XXIV. Network Setting
Make the TCP/IP address setting for the network.
Note:
Consult the network administrator for the setting
value to be entered and make settings as
required.
1. Select the function to be used as follows:
Utility/Counter → Administrator Setting → Enter
the Administrator Password → Network Setting
→ TCP/IP Setting → Fwd.
2. Touch "Manual Input" of IP Address Setting
Method and make the following settings.
IP Address: IP address of the controller
Subnet Mask: Subnet mask of the network, to
which the machine is connected
Default Gateway: IP address of the default gate-
way
3. Turn OFF and ON the Main Power Switch.
4. Select the function to be used as follows:
Utility/Counter → Administrator Setting → Enter
the Administrator Password → Network Setting
→ Detail Setting → PING Confirmation, and
make the operation check of TCP/IP.
9J06IXC024DA
E-15