Replacing Heat Process Temperature Sensor - Konica Minolta drypro 832 Service Manual

Chapter 9 Replacing Loading Parts in Heat Process Unit
9.1.3

Replacing Heat Process Temperature Sensor

The temperature sensor that monitors the temperature of the heater cannot be replaced singularly. Replace a
complete set of the heat process unit.
•
Be sure to turn off power and remove the power cable from the electrical outlet before
removing or installing the exterior cover or replacing loading parts.
Caution
•
The heat process unit and the area around it are hot immediately after turning off DRYPRO
832. The upper part of the rack is particularly hot. Touching it with bare hands may cause
burns. Therefore, use working gloves, and hold the grips on the side panels.
Work outline
The number of personnel and the estimated work hours required to replace loading parts is as follows:
Number of
Personnel
1
Requirements
The procedure for replacing loading parts requires the following tools:
No.
1 Various types of screwdrivers
3 A complete set of heat process unit (for
replacement)
2
Replace a complete set of heat process unit removed.
3
Install the heat process unit and left cover with reference to
9-5)" in "9.1.1 Removing/Installing Heat Process
4
Return the supply tray and tray shutter to their original positions.
Take sufficient care when handling the tray shutter, as it may be impossible to insert if it
becomes deformed due to rough handling.
Caution
This is the end of the process of replacing the heat process temperature sensor.
9-8
Work Hours
10 minutes
Tools
1
Remove the left cover and heat process unit with
reference to
in
Caution
No. Tools
2 Tray (container for screws and parts
removed)
4 Cotton work gloves
" Removal Procedure (Page 9-3)"
"9.1.1 Removing/Installing Heat Process
•
When replacing loading parts, be sure to
replace with the tray shutter attached. If
some of the film remains on the tray, the
film may be exposed.
•
The heat process unit weighs
approximately 15kg.
Carefully perform work when unloading
the heat process unit from the main unit
or transporting it to work site.
•
Be very careful, the top of the rack is hot.
" Installation Procedure (Page
Unit".
Unit".